INTERNAL DIMENSIONS
 Length: 2000mm
 Width: 2,000mm
 Height: 2,000mm
  
 TYPE OF HEATING: ELECTRIC
 TEMPERATURE: MAX. 220°C
 DOOR TYPE: CONTAINER Type 1 Piece
 OVEN BODY MATERIAL : 150 mm, rock wool insulation, powder coating
  
 Galvanized sheet 1.2 mm
  
 FAN CAPACITY AIR CIRCULATION UNIT: 4000 M3
 /h
 FAN MOTOR: 2.2 Kw/h
 THERMAL CAPACITY: 21*2Kw
 EXHAUST FAN CAPACITY: 1,000 M3
  
 /hx 1 time adjustable
 FAN MOTOR: 0.55 Kw/hx 1 piece
  
 TEMPERATURE CONTROL: PT 100
 TOTAL ENERGY: 43 kW
  
 Use: epoxy powder polymerization
 - Maximum temperature: 220°C
 - Material of the outer surface: Steel
 Cold Rolled 1mm
 - ,Inner surface material:
 1mm galvanized steel sheet
 - Insulation thickness: 150 mm
 Insulation: Base - 50 mm rock wool
 (50kg/m³)
 - Side walls - 150 mm rock wool
 (50kg/m³)
 - Roof - 150 mm rock wool (50 kg / m³)
 Heat transfer: Convection, by
 closed air circuit
 - Type of heating: Direct heating with
 electric resistors
 - Temperature control: on /
 stop, digital thermostat 0-400 ° C,
 Fe-Const Thermocouple (Type J)
 - Ambient temperature: + 10 ° C (during the
 work)
 - Oven uniformity: ± 2.5ºC (5ºC total)
 - Control accuracy: ±1°C
 - Heating time: 25-30 min (empty oven)
 - Oven doors: manual, hinged,
 on both sides
 - Trolley: 2 pieces, a frame with wheels
 flows
 - Loading / unloading: pushed to the
 workshop hand in the oven
  
 Adjustable air blast openings on the air duct at the base of the oven maintain even air distribution at the set temperature.
  
 The temperature controller is of the digital type, allowing sensitive adjustment of the oven temperature.
  
 1.1. HEATING UNIT
 Source: electricity
 - Circulation fan: 4,000 m3 / h
 2.2 KW - 50Hz, body and impeller in sheet metal, non-ATEX
 - heating energy consumption: 63
 KWh, power required to reach
 200°C in 30 minutes (empty oven)
 - Resistance Type: Resistors
 tube type serpentines
 - Insulation: rock wool 150 mm
 The heating unit is insulated with a
 high-density insulating material, mounted at
 the rear of the oven and has the capacity
 increase the oven temperature to
 220°C.
  
 The circulation fan is located inside the heater unit which maintains high efficiency circulation. The resistors are mounted in a deflector fashion to provide maximum heat transfer to the circulating air while passing through this area.
  
 The heating unit includes a resistance cell, a circulation fan, a maintenance cover and an electrical installation up to the control panel.
  
 1.2. CART
  
 Trolley frame with cast wheels is included. The necessary additional carriage, its design, moving mechanisms, additional supports, construction, etc. will be the responsibility of the buyer.
  
 1.3. CONTROL PANEL AND ELECTRICAL INSTALLATION
  
 The electrical control panel is mounted on the oven and the internal wiring has been carried out. The control panel consists of SCHNEIDER ELECTRIC control panel elements.