1. EPOXY GAS OVEN
 INTERNAL DIMENSIONS
 Length: 3,800mm
 Width: 2,000mm
 Height: 2,000mm
 Use: polymerization  epoxy powder
 - Maximum temperature: 220°C
 - Exterior surface material: Steel 
    Cold Rolled 1mm
 - ,Inner surface material: 
     1mm galvanized steel sheet
 - Insulation thickness: 150 mm
     Insulation: Base - 50 mm rock wool 
    (50kg/m³)
 - Side walls - 150 mm rock wool 
    (50kg/m³)
 - Roof - 150 mm rock wool (50 kg / m³)
     Heat transfer: Convection, by 
     closed air circuit
 - Type of heating: Direct heating with 
     electrical resistances
 - Temperature control: on / 
    stop, digital thermostat 0-400°C,
    Thermocouple Fe-Const (Type J)
 - Ambient temperature: + 10 ° C (during the 
     work)
 - Oven uniformity: ± 2.5ºC (5ºC total)
 - Control accuracy: ±1°C
 - Heating time: 25-30 min (empty oven)
 -   Oven doors: manual, hinged, 
     both sides
 - Trolley: 2 pieces, a frame with wheels 
    coulées
 -  Loading/unloading: pushed to the 
     workshop hand in the oven
 Adjustable air blower openings on the air duct at the base of the oven maintain even air distribution at the set temperature. 
 The temperature controller is of the digital type, allowing sensitive adjustment of the oven temperature.
 1.1. HEATING UNIT
   Source: electricity
 - Circulation fan: 7.500 m3 / h 
    3KW - 50Hz, body and impeller in sheet metal, non-ATEX
 - heating energy consumption: 63 
   KWh, power needed to reach 
   200°C in 30 minutes (empty oven)
 - Resistor Type: Resistors 
     tube type serpentines
 - Insulation: rock wool 150 mm
     The heating unit is insulated with a 
     high density insulation material, mounted at 
     the back of the oven and has the capacity 
     to increase the oven temperature to 
    220°C. 
 The circulation fan is located inside the heater unit which maintains high efficiency circulation. The resistors are mounted in a deflector fashion to provide maximum heat transfer to the circulating air while passing through this area.
 The heating unit includes a resistance cell, a circulation fan, a maintenance cover and an electrical installation up to the control panel.
 1.2. CART
 Trolley frame with cast wheels is included. The necessary additional carriage, its design, moving mechanisms, additional supports, construction, etc. will be the responsibility of the buyer.
 1.3. CONTROL PANEL AND ELECTRICAL INSTALLATION
 The electrical control panel is mounted on the oven and the internal wiring has been carried out. The control panel consists of SCHNEIDER ELECTRIC control panel elements.
  
 powder coating oven 
 epoxy oven 
 powder application oven